In this part we are going to build the light structure for your LED boards.
Pick your 2 remaining PVC tubes and put it over your SCROG net.
You have something like this.
Use the same zip tying technique previously used for the SCROG net to attach the solid net.
Do it only on one side to begin.
Roll out your solid net to the other side and attach it with zip ties.
Cut all the extra plastic of your zip ties.
Now get your powerful LED boards (Samsung LEDs are the best) out of the box and place them over your solid net.
Zip tie the corners of your LED boards to the solid net.
Replicate on all the other LED boards and cut the extra plastic of your zip ties.
Do a little bit of cable management.
Cut cut cut.
You should have something like this.
If your boards are a bit heavy, you can add an extra pvc tube in the middle to strengthen the structure.
Now call your buddy and flip upside down your LED structure.
Now take your base, put it on the floor and complete the metal structure of your grow tent.
Put your grow tent’s cover over the metal structure.
This part is way easier with a buddy helping you.
Bravo ! You have nearly completed your grow tent.
Now let’s plug it.
Upper your solid and plastic gardening net and the desired level.
Then put zip ties under each “T” shaped PVC corner, this will maintain the structures at the right level.
You can always move them upper or lower after to fit your plants growth.
Now take your power supplies and put them outside passing them through your grow tent wiring hole.
You don’t want those inside your grow tent.
Cut all the extra plastic from all your zip ties.
Finally plug your power supplies and let it shine !
Well done you are now in possession of a damn good SCROG Tent and ready to grow !