Now that everything is in place, we need to plug the leds and blower to something.

We’ll use the driver we’re developing as an open-source project called SuperGreenDriver, it’s a single device (no more timers, no more multi sockets etc…) plugged to a 24V Power Supply that monitors all the bucket.

And everything is connected so you can access on you smartphone, laptop, and online if you want to.

More info


step91.gif
step92.gif

#1-1

We’re going to put the device at the front of the SpaceBucket, so that the main board’s led is visible, it can show important notifications.

Place the driver where you want it to, be sure that you have enough cord to plug the blower in.

Mark the driver’s holes with a marker.

step93.gif

Make them easily visible.

step94-web.jpg

Good.

step95.gif

#1-2

Now make the holes, be sure to make the holes through the mylar too.

step96.gif

#1-3

Add small zip ties.

step97-web.jpg
step98.gif

#1-4

Now hold the driver in place with your thumb, and flip it upside down, use other zip ties to tighten them, don’t tighten too much at first !

step99.gif

#1-5

Do a first pass without tightening, then when they’re all in place, tighten a bit, not too much, don’t bend the driver !

step100.gif

#2-1

The leds’ wires are still inside the bucket, make hole at the top, just above the driver, double check that there’s nothing under it tho.

step101-web.jpg

The hole should be wide enough so you can get the wires and their plug through it.

step101bis-web.jpg

#2-2

Once you got all cables through the hole, plug them to the driver.

step102.gif
step105.gif

#3-1

Put the V-Scrog Pot in the bottom pot (with the wheels), and plug the driver to your 24V Power Supply.

step106.gif

Now go to the next section to learn how to do this.

MainPageApp.png