Let’s add a brain to our tv-bench !
It’ll do stuff like:
Configure everything from an app or a computer
Setup light schedules
Blower and fans power
Connect sensors, like temperature/humidity/etc…
Create cool dashboards to monitor when you’re not home
Gives cool alerts for when things go wrong (temperature out of range, power outtage etc…)
Alright, grab the main board.
This one’s a SuperGreenDriver, it has the main advantage to be totally integrated and plug-and-play. No need to buy additional drivers, you can go up to 6 led panels on this one.
Place it under the fans against the wall and mark the holes with a pen.
Get the driller and make the holes, they should just be big enough to get zip ties through them.
Get the driver and zip ties.
Place the driver in place and add the zip ties through it.
Now it should hold in place. Get to the other side of the bench.
Use other zip-ties to tighten everything.
And cut the zip tie tails.
Ok so now we have to make a rather quite large hole.
On swedish furniture, the back panel is quite thin, so you should be able to use the drille like a CNC head.
Or just use a driller with a big-enough drill wick.
So we got a discontinuity error here, then step where we plug everything is just below.
Get the blower and power wires through the hole.
Plug everything in, the blower and fans plugs are indicated on the board.
Then plug the main power plug.
If it does not light up for you, don’t worry.
You should at least have the blower and fans on.
Cable management yay !
Get them zip ties.
I’m not that good at cable management. But at least it should prevent snatching a wire with a plant or something..